Ask
27

First honey crop with one hive and no extractor — is buying one mad, and what do people actually do?

One hive, second season, and there is finally capped honey in the super. About seven frames of it.

Every guide assumes an extractor. The cheapest one I can find costs more than everything else I have spent on this hobby put together, and it would be used for perhaps an hour a year.

The alternatives I have read about are crushing and straining, or cutting comb honey, both of which apparently destroy the drawn comb. People say drawn comb is the most valuable thing a colony makes, which makes me think I would be trading something expensive for something cheap without understanding the exchange rate.

What do people with one or two hives actually do, and what is the real cost of the low-equipment route?

2 answers Share
Report

Answering anonymously — a moderator will review it first.

  • @borrow_the_kit · 6h ago

    Before you decide anything, find out whether you can borrow one. This is the answer for most people with one or two hives and it barely gets mentioned.

    Local beekeeping associations very commonly own an extractor and lend it to members, sometimes with a shared room set up for it. Some charge a small fee, some are free with membership, and membership is usually cheap enough to be worth it for the other reasons anyway.

    Why it is worth asking even if you were happy to crush:

    • You keep the comb, so the question disappears rather than being traded away
    • Extractors are much easier with two people, and a shared setup usually comes with someone who has done it before
    • You find out whether you even like the process before spending anything

    The practical catch is timing. Everyone wants it in the same three weeks, so book early and be flexible.

    If there is no association nearby, ask any beekeeper within reasonable driving distance. Most people with a few hives own one, use it for an afternoon a year, and are entirely willing to lend it — particularly to somebody who turns up with their own frames and takes them away again.

    Buying is what you do at the point where borrowing has become annoying, which for most hobbyists is somewhere above three or four hives.

    25
    Share
    Reply

    Answering anonymously — a moderator will review it first.

    Report
  • @crush_and_strain · 6h ago

    You have understood the trade correctly, and then overestimated one side of it. Drawn comb is genuinely valuable, and at your scale it is not worth an extractor.

    What the trade actually is. Drawing comb costs the colony a lot of nectar and a lot of bee-hours, so an extracted frame handed back is a real head start — the colony can fill it immediately instead of building first. Crushing destroys that. In a big operation, over many boxes and many years, that difference compounds and pays for the machine.

    With one hive, it does not. Seven frames a year of rebuilt comb is well within what a healthy colony does during a decent flow without noticing much. You are trading a modest amount of colony effort for several hundred in equipment that sits in a shed for the other eleven months.

    Crush and strain, practically. Cut the comb out into a bucket, mash it, and let it drain through a coarse then a fine strainer overnight in a warm room. That is the whole method. Warm helps a lot; cold honey barely moves.

    What you get back. Wax, which is the part people forget. Seven frames of comb is a real quantity of wax — worth rendering, and it has value or use of its own. Counting that, the exchange looks better than the bare comparison suggests.

    One caution: strain more than you think you need to. Fragments of wax in the jars are the usual first-year disappointment and they are entirely a straining problem.

    30
    Share
    Reply

    Answering anonymously — a moderator will review it first.

    Report