Ask
27
@no_ear_at_all ·

The loaf tastes good and looks like a boulder — the blade drags and it splits at the side instead of opening

Crumb is good, flavour is good, rise is decent. The scoring is where it falls apart.

What happens: the blade drags through the surface rather than cutting it, so the cut is ragged. In the oven the loaf does not open along my cut at all — it bursts along one side near the bottom, and I end up with a boulder with a tear in it.

I am using a razor on a stick, scoring just before it goes in, on dough straight from an overnight retard in the fridge.

I would like to understand what governs this rather than trying a different angle each week. What decides whether a loaf opens where you cut it?

2 answers Share
Report

Answering anonymously — a moderator will review it first.

  • @blade_angle_bora · 6h ago

    Two separate problems and it is worth fixing them in order, because the second one is caused by the first.

    The drag is the blade and the angle. A razor pulled through dough at ninety degrees is trying to part it, and wet dough is sticky enough to follow the blade instead. What you want is a shallow angle — close to thirty degrees to the surface — and one confident, fast stroke. At that angle you are cutting a flap rather than a trench, and it takes far less force.

    Depth matters too: for an ear you want a cut about half a centimetre deep, not a scratch. Shallow scores are the most common cause of no ear at all.

    The blowout at the side is the loaf finding its own weakest point, and that happens when your cut did not give it a better one. The dough expands hard in the first minutes; if the score is too shallow or dragged and closed up, the pressure goes wherever the crust is thinnest — usually low on the side where the dough met the banneton.

    So the sequence to fix: deeper cut, lower angle, faster stroke. When the cut is doing its job, the loaf opens there because that is genuinely the easiest path, and the side tear stops happening on its own.

    One practical note: a razor blade on a stick is the right tool, and it must be sharp and clean. A blade with dried dough on it drags no matter what your technique is.

    30
    Share
    Reply

    Answering anonymously — a moderator will review it first.

    Report
  • @cold_dough_cuts · 6h ago

    You are already doing the biggest thing right and may not know it: cold dough from the fridge cuts far better than room temperature dough. If you ever score at room temperature and wonder why it is worse, that is why.

    A few things that make the cut cleaner still:

    Score the moment it comes out of the fridge, not after it has sat on the counter while the oven finishes heating. Ten minutes of warming makes a real difference to how the surface behaves.

    A dusted surface cuts more cleanly than a bare wet one. A light dusting of flour before scoring, brushed off after if you do not want it visible.

    Do not saw. One stroke. If you go back over a cut it drags and closes, and that is often what turns a good score into a ragged one.

    Wet the blade if it is still sticking — a quick dip in water between loaves.

    On steam, since it is connected to your result: without enough steam the crust sets too early, and a set crust cannot open however well you scored it. That produces exactly the boulder shape. If you are not baking covered, or in a Dutch oven, that is worth checking before you spend more weeks on angles — plenty of no-ear problems are steam problems wearing a scoring costume.

    25
    Share
    Reply

    Answering anonymously — a moderator will review it first.

    Report